I have installed a RTD whose length is 2250mm(RTD stem length), but it's up

I have installed a RTD whose length is 2250mm(RTD stem length), but it's upper 200 -250mm is out of the reactor, and this upper 200mm stem is surrounded by atmospheric temp. And the lower portion i.e. 2000mm is in contact with the measuring fluid, then does the final measuring temp. Gonna change as the upper 200mm RTD stem is out of reactor?

Question Posted / aniketskadam007

1 Answers
2647 Views
Process Control Technologies, I also Faced
E-Mail Answers

I have installed a RTD whose length is 2250mm(RTD stem length), but it's upper 200 -250mm is ou..

Answer / narendra sharma

No, RTD only show temp. According to stem bottom part

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.

0 Answers

what is the full form of psig.

8 Answers

Which standard is used for calibration of Control Valves ?

2 Answers

how to calculate range of level transmitter?

0 Answers TCE,

I need circuit for RTD senser?

0 Answers

Isometric drawings are generated during _________________ phase of a project

0 Answers

while stroke checking of a linear control valve ,found its travel is in non linear ,what can be possible reason ? ( please answer send in mannanali65@gmail.com) pls pls pls if any body know

2 Answers JAL International,

what is Dry Leg calibration and where is it used

1 Answers Petrofac,

WHAT IS DIFFERENCE BETWEEN TWO WIRE RTD AND THREE WIRE RTD?

5 Answers Yokogawa,

What is the Difference between PE,IE and ISE

2 Answers

Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.

0 Answers American Steel,

How find CGPA? when marks are 515/850 & 2559/3350. Plz any one tell me.

1 Answers

For more Instrumentation Interview Questions Click Here