What is capacity of impulse line tube ...answer in psi

Question Posted / ramakrishnaa

2 Answers
11278 Views
Shell, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is capacity of impulse line tube ...answer in psi..

Answer / ramakrishnan

200 kg/cm2

Is This Answer Correct ?

5 Yes

0 No

What is capacity of impulse line tube ...answer in psi..

Answer / carl_ellis

Theoretical burst and working pressure in psi at 100 degrees F

Pressure Formula:
Internal Burst = 2 St/D
Where
P = Internal pressure psi
S = Tensile stress psi
t = Minimum wall thickness in inches
D = Nominal outside diameter in inches

Working pressure = 1/4 internal burst pressure

Carl Ellis
Measure First

Is This Answer Correct ?

3 Yes

2 No

Post New Answer

More Instrumentation Interview Questions

what is the procedure of O2 sensor(ABB) calibration?

0 Answers Aramco, Samsung,

I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?

3 Answers OPaL,

selection of the zener barrier for the hazardeous area zone 0

0 Answers Siemens,

WHY WE WILL USE 0-24VdC IN ELECTRONIC CIRCUITS AND INSTRUMENTATION TRANSMITTERS?

3 Answers Aban Power, Jindal, JSW, Sugar Factory,

How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.

0 Answers Petro Rabigh,

My rtd working well at the same time r/i converter is not working properly.when power is given to rtd..it is giving 30mA and getting 2.4 mA if i remove the compensate leads No matter how many ohms.why it is happening like so?what is the solution?rtd range-0-200deg c& 4-20 mA o/p.please give me solutiin anyone......

1 Answers

For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.

0 Answers

what is the input to be given digital temp controller during the the calibration time?

2 Answers

What is meant by cold float of compressor shaft.

1 Answers Sabic,

The performance of a pump is monitored by measuring the ________ and _________ pressures

1 Answers

Can anyone say that formula of Converting the Diff. Pressure into Flow in Kg/Cm2 or any explaniation of Orifice Plate, Beta Ratio , How to calculate

1 Answers

What is the difference between radar and ultrasonic level transmitter? Which method is best and more accurate?

8 Answers

For more Instrumentation Interview Questions Click Here