Interested to Buy Any Domain ? << Click Here >> for more details...
What is capacity of impulse line tube ...answer in psi
- 2 Answers
- 11387 Views
- Shell, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
Theoretical burst and working pressure in psi at 100 degrees F
Pressure Formula:
Internal Burst = 2 St/D
Where
P = Internal pressure psi
S = Tensile stress psi
t = Minimum wall thickness in inches
D = Nominal outside diameter in inches
Working pressure = 1/4 internal burst pressure
Carl Ellis
Measure First
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
Explain the working of rota meter.
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
What is the difference between working pressure and calibration pressure of a control valve
If P will increase then what will happen with PID?
what is performance test.need defination
Why boiler chimney area oxyden sensor fixing?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
in mass flow meter what is drive friquancy ?
How to Calibrate Flow Switch in field
what is a half wave, full wave, and bridge rectifer.
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
what is the difference between profibus and controlnet networking.
