Answer / panchjai

Surge is due to the insufficient pressure, flow at suction. this causes the compressor to move to unstable region called surge.

Provide anti-surge controller which is of multi variable controller type to supply enough flow at the suction by recycling the discharge of compressor.

Answer / paresh rathod

Provide anti-surge controller which is of multi variable controller type to supply enough flow at the suction by recycling the discharge of compressor.

Answer / md amir rahman

There is Vacuum indicator used in suction line to determine surge in compressor.

what is the difference between dcs & plc

2 Answers  

---

The DCS has the following signal type:

3 Answers  

---

How would i calibrate a new commissioned flow transmitter???

3 Answers  

---

how can I install "operating system " in may HART communicator? It is damaged, and it doesn't boot up.

1 Answers   ARPC,

---

Do you have reference list?

0 Answers  

---

NAME ANY TWO ELASTIC PRESURE SENSOR?

2 Answers   DVC,

---

on which principle control valve works?

3 Answers   Lupin, Reliance,

---

State some of balance principle’ advantages?

0 Answers  

---

What is instrumentation instrumentation engineering?

0 Answers  

---

how to calibrate differential pressure switch

2 Answers  

---

What is shriking and swell effect for a boiler ?

1 Answers  

---

what is the daily job of an instrument commissioning supervisor

1 Answers   Petrofac,

---