Is there any smart plant instrumentation design training institute in Bangalore?
No Answer is Posted For this Question
Be the First to Post Answer
In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
How to carry out hot loop checking of closed loop pf temperature control valve & temperature transmitter?
what is the use of glycol filling in seal pot (or) condensate pot in instrument impluse line?
what is difference between OP AMP and differential amplifier?
What is the cascade control system and where is use in power plant give the detail with block diagram
what is RPI and NUT in controlnet networx. what happen if we are increase the NUT of controlnet networx?
GWR radar transmitter working principle?
how pressurize drum calibrated ?
How to work DCS? how to get the signal from Field Instruemtns to PIB to Console?
what is Micro-switch and where it is used......?
how to measure the output of RTD given the general formula of rtd.