What is meant by cold loop test in instrument
No Answer is Posted For this Question
Be the First to Post Answer
If i=10+10sin314t then find the rms and average value of current with explain?
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
0 Answers Eprosys Engineering Consultants,
why we use to transmit the power in three phases intead of single phase ?
my 10 hp submersible pump is tripping when connected through ELCB.I have checked the megger value of the coil's with body.It was found to be 0.2mega ohm.that is leakage is there.But when connected to mccb it is not tripping.no leakage current in the motor.Is it safe to connect to mccb? what are the problem's will arise if future?also tell me in ELCB no neutral is connected to motor.than how ELCB was working?
we all know that in transformer, voltage and current are inversely related i.e. Vp/Vs= Is/Ip....so in standard CT..we have a ratio of 200/5...that means our voltage should increase by ratio of 40..althoug that is not the case...because that requires high insulation level.and pratically not feasible......can anybody clarify my ques.......thanx
can we use HPSV LAMP in HPMV LAMP fixture ?and viseversa.
Is there any scope for an electrical engineer in MRF company......
WHAT IS M.P.C.B
why the power factor is low at no load?
what is the dis-advantage of 3 phase 3 wire energy meter?
why abcd parameters are called transmission parameters
why a bulb glow when connected with two end phase and neutral respectively.