Answer / belmiro beve

Pre-Commissioning is the pre-check 0f Input/Output, motor
direction, etc.

Commission is divid in two type:
1. Cold run where we run the plant without product and;
2. The hot run where the plant is runned with product

how do i calibrate mmwc pressure guage with out calibrator.if any? pls give me the ans.

1 Answers  

---

Calibration procedure for electro magnetic flow meter

0 Answers  

---

HOW WE ARE DECIDING WHILE PROGRAMMING IN PID CONTROLLER THAT WE ARE USING HEATING OR COOLING???????

1 Answers   Eskom,

---

Identify the electrical variable that is either directly or inferentially used by various instruments to determine the value of a measured variable.

4 Answers  

---

Isometric drawings are generated during _________________ phase of a project

0 Answers  

---

how to define range of dp level xmeter in open tank

1 Answers  

---

How to check vortex flow meter is in good condition while we do not having calibration setup?

4 Answers  

---

why most of the DP transmitters using maximum range as 0-2500mmwc?why not 1000 2000 3000 4000mmwc

2 Answers   SPIC, TNPL,

---

I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.

3 Answers  

---

If the Barrier Fails during online then What will be the control valve position in field or Positioner action in the field.

3 Answers  

---

In a class of 150 students, 40 passed in Social Studies, 90 passed in Science and 30 failed in both the subjects. vi)How many students passed in at most one subject among Science and Social Science?

7 Answers   CAT, CGI, Cipla, KHK, Visa,

---

Please tell me details about Sox,Nox,SWAS analyser????

0 Answers   Essar,

---