Interested to Buy Any Domain ? << Click Here >> for more details...
What is pre-commissioning and commissioning ?
- 1 Answers
- 7209 Views
- Armco, I also Faced
- E-Mail Answers
Answer Posted / belmiro beve
Pre-Commissioning is the pre-check 0f Input/Output, motor
direction, etc.
Commission is divid in two type:
1. Cold run where we run the plant without product and;
2. The hot run where the plant is runned with product
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
Square root calculation for dp flow transmitter?
what is sliding spool valves?
What do you know about gail?
What is voltage regulator?
what are the selections available in configuring a burnout protection of a controller? thanks
i need some objective type questions in instrumentation
Specify for Cables - Flame Retardant and Fire Resistant?
what is the importance of CV in the control valves? how it is calculated?
why we r opening HOT BYPASS valve during startup of a compressor?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
what are the diff. in servo and regulatory control?
what is exact time to study dcs and plc cources
what are the use of belew gear in general ??
