Middle point of any slab is raised 10-12 mm during shuttering work because

Middle point of any slab is raised 10-12 mm during
shuttering work because––

Question Posted / guest

4 Answers
7917 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Middle point of any slab is raised 10-12 mm during shuttering work because–– ..

Answer / mughalsab

if i dont raised at mid ponit of slab so when we poured concrete then the slab is sag at mid point due to its own weight therefore we raised at mid point so when concrete is poured then the slab is going to its corect position.

Is This Answer Correct ?

9 Yes

1 No

Middle point of any slab is raised 10-12 mm during shuttering work because–– ..

Answer / rj

so as to have a camber at the middle area.

Is This Answer Correct ?

8 Yes

4 No

Middle point of any slab is raised 10-12 mm during shuttering work because–– ..

Answer / bharat gurav

because at middle point act point load & share force act at
L/4 so extra steel r provided...............but at mid-span
no provide extra steel due 2 sla raise 10-12mm

Is This Answer Correct ?

1 Yes

4 No

Middle point of any slab is raised 10-12 mm during shuttering work because–– ..

Answer / amar kantak

FOR POURING CONCRETE

Is This Answer Correct ?

0 Yes

8 No

Post New Answer

More Civil Engineering Interview Questions

What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.

0 Answers Eros, L&T,

undistributed samples are obtained by

0 Answers

What is themeaning of TBM in civil construction

7 Answers

How is rate analysis prepared for M 25 grade of concrete?

4 Answers

What is the best mixing ratio of concrete materiloas for raft foundation?

1 Answers

a rectangle grill of length 72 inch x 20 inch width.how to calculate bar spacing ,bar consist 8 mm thickness and spacing of bar is 2 inch.. calculate no of bar with formula

0 Answers

What is the meaning of unit weight of cement?

2 Answers L&T,

how much cost of single coat 20mm thick plastering per sqre meter

0 Answers

Okay guys I m new here i wanna ask you that ,if i mix two three larger stones (about 20cm dia)in concrete for column or footings what actually happens, how the strength of concrete is reduced? and why it is not allowed?

3 Answers

A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals

0 Answers

What is semirigid connections?

0 Answers

How to defind P.C.C. mix design according ratio & IS coad

12 Answers ITC Infotech,

For more Civil Engineering Interview Questions Click Here