Answer / nagraj jvk

if it is so..the generator generates the value less than that
the bus bar has and thus current flows from higher to lower
potential and inturn runs as a motor if it is very under
excited

PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com

0 Answers   NHPC,

---

A synchronous machines has higher capacity for (1) Leading power factor (2) Lagging power factor (3) Does not depend upon the power factor of machine (4) None of the above

3 Answers   JSW,

---

Define open loop control system.

0 Answers  

---

Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?

0 Answers   Quest,

---

What is meant by unilitrel device?plz tell about h-parametrs

1 Answers  

---

A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .

0 Answers   BUET, VECL,

---

where this neutral connection goes after returning from the load(home ,factory,industries).Is it grounded at the transformer side or atthe generator side .If it is grounded then we also ground the earth connection.is there any problem with this.

1 Answers   IOCL,

---

If there is volagte between earth and neutral, what should be the reason ? and solution * What should be allowable limit in case, if the voltage between earth and neutral exist ? / OR what is limit for safe voltage between earth and neutral?

3 Answers  

---

In India which type of PLCC IS used?

2 Answers   Cipla, Ford, Jayashree,

---

please anybody help me to find out the BHEL trainee Exam previous year questions papers . if u ve pls. send it to surekhared@gmail.com

0 Answers   Bhel,

---

how will you calculate rated Primary and Secondary voltage and Current for 2500 KVA, 11kv/443V Transformer

2 Answers  

---

How to choose the vector group for the step up and step down transformers??? Tell me the which vector group is suitable for step up and step down transformers and whats the reason to choose and whats the benefits???

0 Answers   L&T,

---