An electronic p controller has an input range of 1-5v, and output range of 4-20mA, while testing a step change of 0.4 was applied at the input , the PB setting was 50% ,what should be the change in the output ?

1 Answers   Reliance,

---

what is the input of digital RPM indicator during the calibration time?

1 Answers  

---

Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?

0 Answers  

---

what is the difference between 2 wire and 3 wire RTD- application wise,cost effectivity?

2 Answers  

---

What is diff between Ingral orifice and simple orifice?where it use?

3 Answers  

---

How to calibrate DP transmitter by using HART communicator ?

1 Answers  

---

i have level transmitter -400 to 0 range for steam drum application but i am unable to calibrate if installation of lt below lower tap what will be the effect ? and as per std wht is location of lt ,above lower tapping or below

1 Answers  

---

hello.my friends.i am an electronics & instrumentation engineer.i want to know Q1.why lugs use in instrumentation cable termination? Q2.if limit switch not working what to do?

2 Answers  

---

why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?

1 Answers  

---

what is the advantage by using PID controller than P& PID?

1 Answers  

---

Functions of electropneumatic valve positioner:

4 Answers  

---

Explain level troll principle & interface level measurement.

1 Answers   ADMA OPCO,

---