Answer / elvis nketiah

:army forced

thru which signal does µP communicate with memory

3 Answers  

---

What is the working principle of oxygen analyzers(zirconium oxide type) used in CFBC boilers?

3 Answers   Bajaj, Kohinoor, Wartsila,

---

I am using Capacitive type level transmitter for measuring oil level in a closed tank (lub oil tank). The txs range is 1500mm, and they do hunt regularly (for about 45mm), can anybody tell what could be the reason??? or any other type level tx that could be used to avoid this?

1 Answers  

---

What's the Installtion procedure of DP Transmitter for Gas,steam and water?

2 Answers  

---

What is Modbus communication

0 Answers  

---

what is unit and element of viberation?

1 Answers   Kentz, KOC,

---

what is difference between pressure,flow and level control valve.

3 Answers  

---

How d.p. Transmitter can be applied to close tank?

0 Answers  

---

.how does CSADA systems display the process variable value?

2 Answers   Empower,

---

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers  

---

How much flow is passing through 6 inch line? There are no gauge, no any transmitters in line.

3 Answers  

---

A pressure differential gauge type of instrument has a manifold with 2 isolation valves (hp and lp),2 vents(1 each for hp and lp) and 1 equalizing valve. Determine the position of each valve(either fully closed or fully open) when troboulshooting to: 1. zero the transmitter. 2. determine if there is a block in the impulse line. 3. determine if the gauge is functioning properly. The process fluid is water.

1 Answers  

---