What should be cable size for 75KVA 380/220 3ph transformer
Answers were Sorted based on User's Feedback
Answer / shashi
P=1.732VI
SO P=75KVA(75000 VA)
V=220 V
I=236
Considering safety you can lay aluminum cable of 240 sqmm or 95 sqmm copper cable
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / raja
4c x 50mm² Armoured Cable + 1c x 25mm² Earth Cable
Is This Answer Correct ? | 2 Yes | 3 No |
Answer / essemmay
thanx raja..is it possible 50mm2 for both side cables..incomer and outgoing of the transformer, since the incomer voltage is 380 and outgoing is 220, so the same size is enough??
Is This Answer Correct ? | 0 Yes | 2 No |
Why Humming noise originated in Starter motor and how it was generated ?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
why secondary of c.t. will kept open ?
why do we prefer -48 volt instead of -24volt or -12 volt etc. ??
What is the difference between an insulator and a dielectric?
improve power factor by : 1)shunt reactor 2)shunt capacitor 3)series capacitor 4)series reactor
what happen to the voltage and current in all phases when an earth fault occur in a phase in three phase three wire system(delta connected)...
Is itnecessary to use capacitor in an Fluorescent Tube Light Fixtures? Why? What if not capacitors are not included?
how to calculate the cable size depending on the amps?
why dc series motor has high starting torque
how the speed of the gets motor regulated. does it draw the same current on the all speed level.