Answer / db

refer the torque slip characteristic with star delta starter you will get it

Hello, im taking an introduction to PLC..and i'm having a hard time on creating a program for 2 lamps blinking alternately with this button characteristics: 1.) One push button (starts upon pressing) 2.) Same push button (when pressed again, will pause the system) 3.) Same push button (when pressed again, will continue the paused system) 4.) Same push button (when pressed within 2 seconds, will shut off the system) Pls..i know this is just a simple problem for you guys..

2 Answers  

---

1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?

0 Answers  

---

what is the use nuetral wire

8 Answers  

---

Why we are use 11KV / 22KV / 33KV / 66KV / 110KV / 230KV / 440KV this type of ratio. why cant we use other voltage ratio like 54KV / 99KV et.,

8 Answers   College School Exams Tests, Hino, ITC Infotech, Reliance, UPRVUNL,

---

what is the difference between equipment earth and system earth.

1 Answers   Hofincons,

---

Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter

0 Answers  

---

Why the output of OP-AMP is always less than Vcc?

0 Answers  

---

why induction motors are rated at 0.8 power factor.

0 Answers   Bhel, TN,

---

Is current shock due to voltage or current? pls answer

2 Answers   ABB,

---

Hi i want to know that in generation station what we are generate either voltage or current

1 Answers  

---

what parameters should we check to reduce the power bill

0 Answers  

---

What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.

0 Answers   GNFC,

---