Why we use duplex coil and hook switch in telephone system?



Why we use duplex coil and hook switch in telephone system?..

Answer / Amla Rani

Duplex coils and hook switches are used in telephone systems to allow full-duplex communication, which means both parties can talk and listen at the same time. The duplex coil is a device that enables current flow in one direction during transmission and in the opposite direction during reception, while the hook switch completes the circuit when the receiver is lifted or hung up.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

What are instrument transformers?

6 Answers  


What is safety of Ht panel

1 Answers  


we the the value of frequency is 50 HZ in DG then why we said the value inductive rectance is zero in DG?

1 Answers  


How to select a contactor? How many types of contactors are available

1 Answers   TCS,


Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?

1 Answers  


234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,

1 Answers   Jomel,


How voltage regulation is calculated for over head transmission line? What do we mean by Conductor constant while calculating voltage regulation? how it is differ for for diffrent type of conductor say AAAC DOG & AAAC RACOON conductor?

3 Answers   ABB, AES,


LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values

1 Answers  


why holding contact is not using in VCB and ACB breakers?

1 Answers   Cethar,


Generator protection &generator test

1 Answers  


derive the formula of amp hours is calculated for 12v battery.where no. of plates is given

1 Answers  


What is force on parallel conductors ?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)