Answer / praveen kumar

Governor input is RPM....and based on setpoint it give 20-200ma to servo actuator, it increase actuator open or closing based on the setpoint and process variable(rpm) errors...its a simple controller oly...but the output range was changed....

control panel design guidelines

1 Answers  

---

why we are using orfice plate? then difference between orfice 7 nozzle plate?

1 Answers   Flour Tech Engineers (P) Ltd,

---

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?

1 Answers  

---

what is the role of proportional in process control?

6 Answers   OGDCL, Trident,

---

Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plants instrumentation field , which one field is give long life & which one field is best ,I confused a lot And also I'm studying AMIE, can I choose which field from Section B examination?

1 Answers  

---

What is diffrent profibus & OFC Communication

1 Answers   Priya Cement,

---

How we will check whether the proximity, which we have is either NPN or PNP, if no data sheet or manual or any details is available to us ???

1 Answers  

---

difference b\w a transducer and a sensor

4 Answers  

---

types of cable..? Use of every types of cable..?

1 Answers   Hindustan Zinc,

---

how do we commission inergen system?

1 Answers  

---

I have flow transmiter DP range is 0 to 5000mmwc,(convert) Display to be show in m3/Hr.

3 Answers   Orient,

---

How to interfacing microcontroller with a DC motor

1 Answers   JJ Tech,

---