What is diffrent profibus & OFC Communication
Answer / vijay krishna
profi bus communication is not suitable for more distance
and will be get affected by emf.signal strength will also
low compared to ofc commn.only thing is less expensive.
|Is This Answer Correct ?||5 Yes||1 No|
Why Flow measure in Square-root?
Paper Details: company -- Hindustan Copper Limited post -- GET 2008 Date -- 03.08.2008 Dept.-- Electronics?Instrumentation Aptitude -- 70 Technical-- 80 Total Time -- 2hr 30min I have listed the question I could able to remember 1. BCD equivalent of 43 2. value of K for stability of a system from a given equation 3. transformer connection for darlington connection 4. damping of balastic galvanometer 5. advantage of chart-pen recorder over CRo 6. CRO - how to change bandwidth 7. questions on CRO construction 8. reverse saturation current of si diode 9. advantage of wire wound resistance over carbon resistance 10. core material for a small coil 11. max fanout-- TTL/ECL/CMOS/MOS 12. component of resistance of monolithic IC 13. functions of capacitors in multivibrators 14. to change a sawtooth signal into a square wave we use-- schmit trigger/ schottkey diode/ zener diode 15. relation b/w á & â in transistor ckt 16. function of SiO2 layer in fabrication 17. 3 questions on ODD MAN OUT
how to use level tranasmitter in closed tank application.?
You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground
Sitrans LR460 Radar level transmitter getting level out or disturbed level during moisture present in the material ie coal in the pccb bunker in CHP.Any suggestions for this problem...????
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL? INSTEAD OF 4-20mA.
Ohm’s law, kirchoff’s law, pascal’s law, Bernoulli’s therem,
How can measure flow in oil line?which type of transmitter is generally used?
how many types of thermocouple cable are? give the name of each type.
What is a PID?
why pneumatic control signal output is use 0.2 to 1 kg/cm2