why 2 APH used in one boiler
Answers were Sorted based on User's Feedback
Answer / vikas
i think 4 increase the efficiency ...the no of aph doesnt
matters lot.it matters is how much we get out of it.
Is This Answer Correct ? | 8 Yes | 0 No |
Answer / divyesh tailor
It is totally dependent on the overall design. That means
generally in any boiler it is to be decided from the total
air flow. Also we do have two FD fans and Two PA fans
running in normal opertaing conditions. So as to match with
the design of the ducting. otherwise we have to modify the
ducting as well. And it is economical also.
Is This Answer Correct ? | 7 Yes | 0 No |
in aviation, How does control valves work?
What is the purpose of bilge separator
If you have a valve with an applied pressure, how do you determine the stress to the closed and open valve?
Why start up vent is fully kept open when boiler is lighted up?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
I need BHEL Engineer Trainee written test papers in Mechanical stream.
DURING STEAM BLOWING OF PIPE LINE, A BLUISH COLOR CONICAL PATTERN IS OBSERVED AT THE END OF PIPE. WHATS THE CONCEPT BEHIND IT?
What is a magnetic valve of refrigeration system?
what is the pump cavitation?
2 Answers IOCL, KCC, Wohr Parking Systems,
• Are you a day-scholar or a hosteller?
if HR asks about, to tel us about automobile engineering wht should we answer him