Answer / Sourav Yadav

In a three-phase generator, current flows from the generator to the load through each phase's positive line (line conductor), negative line (return or neutral conductor), and neutral point (common point between all phases). The neutral point serves as a reference for measuring voltages and balancing current.

how water evaporated in sea

1 Answers   OGDCL,

---

These questions were asked at NICL for the post of Administrative Officer(Specialist): 1. Questions on B.Tech Project 2. What is camshaft and its working 3. Shape of a Cam 4. If Otto and Diesel Cycle has same compression ratio that which will have higher efficiency 5. Effect on IC Engine efficiency if inlet temp increased 6. Who is the current world champion in Chess(as of Sept 2012) 7. Sports person involved in dope charges(Lance Armstrong) 8. Formula for Otto cycle efficiency in terms of temperature 9. 2016 olympics will be going to held in which city

2 Answers   Atlas Honda, JL, NIC,

---

What is the trunk type and crosshead type piston

1 Answers   RRB,

---

What is BTU?

3 Answers  

---

"What are specific heat, latent heat and sensible heat?"

6 Answers   RRB,

---

Is it a good sign when thick smoke comes out of a Oil vapor extraction fan of a steam turbine oil sump? What does it indicates?

1 Answers  

---

AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME

1 Answers  

---

What is the difference between Mild Steel and Cast Steel with full chemical composition and application details.

1 Answers   DAE,

---

What is mean by NPSH? why NPSH available should be more than NPSH required for pump?

2 Answers   Lupin,

---

What is max pressure?

1 Answers   RRB,

---

Why Slag comes on top of weld bead & if ur answer is related to density then think of overhead welding if slag is ligter than weld metal then in overhead welding firstly a laye of slag & then a layer of weld metal must be deposited.

3 Answers   SGS,

---

Can we use pure oxygen in IC engines instead of air?? what would be the advantages and disadvantages of using it?? Have any steps been taken about this??

5 Answers   College School Exams Tests, TATA,

---