Answer / rambir singh

3 to 15 PSI.

A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?

0 Answers  

---

with the help of suitable diagrams different types of control valves

1 Answers  

---

What is the difference between a PLC (Programmable logic controller) and DCS (distributed control system)?

7 Answers  

---

Who to difference between analog in & analog out in dcs?

0 Answers  

---

any body tell me ,contol valve has how many cheractristic? explain it.

6 Answers   L&T,

---

what are the steps I have to deal with?

0 Answers   ONGC,

---

what is difference between differial pressure & delta pressure?

3 Answers  

---

Explain the working principle of lvdt?

0 Answers  

---

why can't we use 5-20mA standard or some other instead of 4- 20mA?

6 Answers   Emerson,

---

If Solenoidal valve works in manual mode but not in Auto mode. What should be the problem?

8 Answers   Bharathi Cement, Titanium,

---

what should be the attitude while answering an interviewer?

2 Answers  

---

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.pls help me

1 Answers   Worley Parsons,

---