Answer / lenin

Hi mydear friend,Transmitter output depends on the
transmitter calibrated range.With out knowing the
transmitter calibrated range diffucalty to tell the output
of the transmitter.If u calibrated the transmitter 0-
120deg.The transmitter ouput will be 20ma at actual temp
120 deg.If u calibrated the transmitter 0-480deg,the
transmitter ouput will be 8ma at 120deg actual temp.

Answer / shankar

Lenin answer is correct. It will be 20mA when the
transmitter is calibrated to 0 - 120 DeG C

Answer / tanveer

lenin answer is 100correct.

Answer / rafeeque

It depends on range of
transmitter otherwise we
cant tell

Answer / sami9-

the above ans is crocet

Answer / sanal sasidharan

The above ans it correct but it will not be 20mA , it should be 16 mA.

Which softwere is required to communicate the S7-300 processor

4 Answers  

What is close loop ?

1 Answers   College School Exams Tests, GMR,

uses of profibus?

1 Answers  

without color coding, without nameplate, without multimeter how can you find the type of thermocouple???

1 Answers   Sabic,

pls any1 sugges me book for plc,dcs & scada..

1 Answers  

Could anybody tell how much amps will a single input to plc will consume?

1 Answers  

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers  

differentiate different units of pressure like US & UK standards

1 Answers  

why we use only 4-20 ma signal as AI and not 0-20 ma?

2 Answers   Honeywell, Oil and Gas Jobs,

What will the new flow factor if D/P Transmitter is RE-RANGED from 25" WC to 50" WC

3 Answers   ADMA OPCO,

What is instrumentation instrumentation engineering?

0 Answers  

Explain ratio control system.

1 Answers