The iron loss in a 100kva transformer is 1 kw and full load copper losses are

The iron loss in a 100kva transformer is 1 kw and full load
copper losses are 2 kw, then what is maximum efficiency occure
at a load?

Question Posted / spal927

3 Answers
9101 Views
MPSC, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

The iron loss in a 100kva transformer is 1 kw and full load copper losses are 2 kw, then what is m..

Answer / awdhesh

70.70 KVA

Is This Answer Correct ?

6 Yes

1 No

The iron loss in a 100kva transformer is 1 kw and full load copper losses are 2 kw, then what is m..

Answer / k.prakashchandra

70 % of full load crrent

Is This Answer Correct ?

3 Yes

0 No

The iron loss in a 100kva transformer is 1 kw and full load copper losses are 2 kw, then what is m..

Answer / srihari

The load is not given so let us assume the load is resistive load.
therefore power factor is unity and at maximum efficiency copper losses = iron losses = 1kw.
100*10^3*1
efficiency= ------------------- = 98.03%
100*10^3*1+1000+1000

Is This Answer Correct ?

2 Yes

6 No

Post New Answer

More Electrical Engineering Interview Questions

How they LT panel busbar size choose

0 Answers

HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????

0 Answers

what is reactive power?, why its measured in VA ? is it transient behavior of system?

0 Answers

Why we use ups battery and dsdb battery in thermal power plant

0 Answers MDeC,

What are instrument transformers?

6 Answers

Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?

0 Answers Sterling Wilson,

what power factor should we maintain to get maximum benefits our organisation load is 10 MW? is it best to maintain the PF at .96 rather than Unity to save electricity bill?

1 Answers

what is the reason for drop in freq. from 50 hz at generating side to 49.8 ,49.6 etc.at receiving side???

2 Answers

What is the power factor of a transformer at no load?

0 Answers

We have one 500KVA transformer. We have tested REF relay and commissioned. After one and half year, due to some ground fault in one of the DB circuit Transformer tripped by REF relay. What will be cause and remedy. Please advise?

1 Answers

what is difference between earthingpits,earthing grid & earthing mess?

0 Answers TATA,

what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing

0 Answers ABB, Genpect,

For more Electrical Engineering Interview Questions Click Here