The iron loss in a 100kva transformer is 1 kw and full load
copper losses are 2 kw, then what is maximum efficiency occure
at a load?
- 3 Answers
- 7349 Views
- MPSC, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
70 % of full load crrent
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
what is the difference between the characteristics of two different phase bushing of any transformer
How RTCC panel is working and give single line diagram for RTCC with transformer?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
What is excitation in case of dc motor?
What is meant by bus bar protection?
Type of motor stater detail and working detail
hi frnds...pls send me aptransco previous papers .....pls..pls,,,(madhar.rocking@gmail.com)and suggest me some websites
what is high - pot test. what's its use?????
What do you mean by cogeneration? What its working principle?
what is integrated ac contact circuit
what is meant by directional earth fault and non directional earth fault? describe both.
How to calculate cable rating for 3 phase supply?
