Why the ratation of fan is anticlockwise all over the
world?

Answers were Sorted based on User's Feedback



Why the ratation of fan is anticlockwise all over the world?..

Answer / bala

As the structure of the fan is concerned with Flemings left
hand rule it results in the direction anti clockwise when u
looking from down of the motor when u view from top it will
be clock wise.But in general all the motors will run in anti
clock wise because of their construction and allignment of
stator and rotor

Is This Answer Correct ?    20 Yes 8 No

Why the ratation of fan is anticlockwise all over the world?..

Answer / simon peter

It is due to the bending pattern of blades at 20° angle......

Is This Answer Correct ?    0 Yes 7 No

Post New Answer

More Electrical Engineering Interview Questions

How do we calculate transformer oil in liter from the rating of the transformer.

1 Answers   BARC,


There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?

1 Answers  


what is the difference between Inverter and ups

1 Answers   L&T, MTS,


what is the diference beteween dedicated earthing & body earthing?

1 Answers  


HOW TO CALCULATE THE CABLE SIZE FOR POWER CABLE, CONTROL CABLE AND INSTRUMENT CABLE

1 Answers   TurboTech,


Then what do you call a transformer that is installed on the ground?"

1 Answers  


what is automatic voltage regulator and it is used?

28 Answers   ACME, TCS,


List some examples of renewable energy?

1 Answers  


why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving

1 Answers   HCL,


how a synchronous motor is used as a resistor,capacitor and an inductor?

3 Answers   Technocon Services,


What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV

1 Answers  


In Ferantti Effect Receiving end voltage is greater than sending end voltage but how it is possible. I know its all about charging current but give me some more detailed explaination?

3 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)