Answer / venkatraman.s

hi friends, this question is most important one for all interview. ans is HT side voltage is high so current is low but LT transformer secondary voltage is low current is high,so we are not connected more cables in TB side so we are using bus bar. its formula is KVA/1.732* volage(HT OR LT)

Answer / perladelsur

As far as I know the reason for that is due to the withstand the dinamic force develop during a short-circuit among other

why transformer are not used in D.C SUPPLY

5 Answers  

---

is the power of a single phase induction motor(Fans) is constant under varying speeds?

4 Answers  

---

TYPES OF TEMPERING OF ENERGY METER

1 Answers  

---

what percentage of marks in B-TECH is needed for section engineering exam

1 Answers   RRB,

---

what ll happen to current if two phases get short circuited

2 Answers   Kirloskar,

---

xplain in detail d pr. of synchronous motors? why syn. generators r used for the production of electricity?

4 Answers  

---

Current chopping mainly occurs in air blast circuit breaker.why?

1 Answers  

---

what is EBXl (electron beam cross linked ) cable ?

1 Answers   Polycab,

---

How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.

0 Answers   vssc,

---

why two point starter,three point starter, four point starter cannot be used for A.C machines?

2 Answers  

---

If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?

0 Answers   Reliance,

---

Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???

0 Answers  

---