Answer / Mohd Sarfaraz

Arc runners and ampere (amp) splitters are used in electrical distribution systems to provide safe and efficient connections. Arc runners, also known as copper runners, are used to jump gaps between phases of a three-phase system during maintenance or installation, preventing arcing. Amp splitters are used to divide the current from a single power source into multiple outlets while maintaining the correct amperage and voltage.

Before i went to bed my master bathroom lights were working fine. At 2 am, when I went to use the lights, none of them were working. The outlets throughout the bathroom work, but the lights and fan above the toilet don't. I have two panels of switches. The one panel has four switches. One of the switches turns on the hall light, and that works. The other three are to other lights, and they don't. The other panel has three switches. One of those is to the fan, and the other is to a light above the toilet. The other is a to light that is also on that other panel. I tried the breakers, and the one that turns off the outlets, marked for the bathrooom, turns on and off the outlets. None seemed to be tripped. I checked the lightbulbs, and they are fine. Please help

2 Answers  

---

Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend

1 Answers  

---

What is the use of bundle conductors?

1 Answers  

---

if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?

1 Answers  

---

What are the types of Transformer? Name them.

9 Answers   Bhel, HSL, NTPC,

---

how to check the continuity of a cable with a megger

4 Answers   Metro,

---

what are the various types of towers used in transmission line

12 Answers   Power Grid, UltraTech,

---

what is d check in dg 1500kva

1 Answers  

---

Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.

1 Answers  

---

Is there any specialised book to refer about fault level calculation both in MV and LV side??

1 Answers  

---

What is the minimum value required for Neutral to Earth in UPS Panels

3 Answers  

---

sugest any typical project ?

1 Answers  

---