Answer / atif rasheed khan

there are two cases arises here, in first case our answer
will be yes under the following condition.
the generator should be so excited till its voltages
produced be equal to the previous step up voltages done
through transformer, however these rise in voltages are just
restricted to 33KV, because beyond this voltage level there
arises a critical issue of the winding insulation.
in this method just reverse the connections, i-e change the
L.T as sending voltage side, and the H.T as generation side.
however in the second case , our answer will be no, if
higher voltage step up transformer are used, due to the
above mentioned problem of insulation of transformer.

Answer / k.prakashchandra

We have to back-charge UGT if the synch is done at generator
output and may be for aux supply

Answer / k.prakashchandra

Yes. If the aux tr is connected to GT and there is no generation ,the GT is back charged with grid duly isolating gen, for aux supply .

why and where we use early make & late break contacts in protection?

0 Answers  

---

In which connection the distribution T/F is connected? a) ▲ / Y b) Y / ▲ c) ▲ / ▲ d) Y / Y

4 Answers  

---

What happens if a three phase induction motor is suddenly single-phased while running? Which type of winding connection will be affected?

22 Answers   B4S Solutions, DRDO, FACT, SL Electricals,

---

how to calculate size of cable from motor current given and how to calculate full load current of a induction motor.

3 Answers   Aarti Steels,

---

How to calculate HV Cable Sizing & what are the factors to be considered for selection?.

2 Answers  

---

why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.

0 Answers   Alstom,

---

Hello friends i am facing one problem in lighting panel. Frequently neutral link near to MCCB is burning(firing. What may be the reason for this one. Please answer me.

5 Answers  

---

How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?

0 Answers  

---

what happens if the phase sequence of parrlel connected sys will changed & phase displacement

1 Answers  

---

Please tell me if you are electrical engineer,and you are appointed for the maintainance of Electrical Power plant,then which parts of the plant deal with you.Also tell how these parts/components work.

1 Answers  

---

What is making & breaking current ???

0 Answers   JLL,

---

why a motor overheated stops to rotate ?????

1 Answers  

---