Can we use generator transformer as step down transformer?
How?
Answer Posted / k.prakashchandra
We have to back-charge UGT if the synch is done at generator
output and may be for aux supply
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
The Q-facr o of a coil given as wL/R. what will be shape of Q versus frequency graph.
What is the types of HT motor testing
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
which types of relay used in acb and vcb?
what is the affect of earth's magnetic field on the frequency used in aircraft???
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
can anybody send the rrb chennai &rrb bopal question papers of 2006&2007.My exam is on 12 oct 2008.Its urgent
What is the limitation of kirchoffs law?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
EXPLAIN THE TRANSFORMER MAINTENANCE?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
Why cables and busbar both needed in LT Panels?