What kind of knowledge we need to gain to draw p&ID and
Isometrics in autocad?
Answers were Sorted based on User's Feedback
Answer / ankur sahu
For isometric drawing:
-G.A Drawing
-Plant north
For P&ID :-
-Material specification
-process flow diagram
-Line list
-process fluid information
Is This Answer Correct ? | 4 Yes | 0 No |
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
These questions were asked at NICL for the post of Administrative Officer(Specialist): 1. Questions on B.Tech Project 2. What is camshaft and its working 3. Shape of a Cam 4. If Otto and Diesel Cycle has same compression ratio that which will have higher efficiency 5. Effect on IC Engine efficiency if inlet temp increased 6. Who is the current world champion in Chess(as of Sept 2012) 7. Sports person involved in dope charges(Lance Armstrong) 8. Formula for Otto cycle efficiency in terms of temperature 9. 2016 olympics will be going to held in which city
2 Answers Atlas Honda, JL, NIC,
At 50 Centigrade (Diesel oil) what is its cast?
How to run AutoCAD lips? What is the uses of lips?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
WHAT IS MEAN BY SS-314(STAINLESS STEEL PIPE GARDE)?
DO WE HAVE NEGETIVE MARKING FOR APPSC(ASST MOTOR VEHICLE INSPECTOR EXAM WHICH IS GOING TO BE CONDUCTED ON 16/6/2013
i am going to appear for section engineer which is conducting by RRB chennai. i want some model question papers my emai ID is chakku_mech10@yahoo.co.in
What is the purpose of gravity disc in centrifugal purifier?
if weld join is failed in radiography what is procudure and its penality
ice can float on the surface of water?
exactly how a vapor bubble can destroy impeller?