What kind of knowledge we need to gain to draw p&ID and
Isometrics in autocad?
Answer Posted / vigneshwar.r
engineering drawing
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What causes cylinder liner-wear down?
What is mean carry over of Aux. Boiler?
Given a cutaway isometric view of the steam turbine.
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?
What for admirality brass used ?
There is a block placed in between air and water. water is at 100 deg cel and air at 50. 1) Draw temperature profile. 2) Why is it curve in air and water?
What is meant by parallel flow heat exchanger?
what is tranformer and transducer
How much should be the minimum and maximum suction and discharge pressure of screw chiller plant.
please send all previous solved question papers on HLL......
If you want to provide water or any chemical @ 50 meter height how much head will you prefer for any selected pump...consider it is M.S pipings...how much friction loss will be there...show with calculation.
Where can you find the feed check valve and feed stop valve and give the purpose of it?
What is railroad track ballast?
i am appearing for the interview of the company SANDVIK??so if u can send me some questions or suggestions on how to prepare,it would be of great help to me.u can send the above at ekjain@yahoo.co.in.thanking you.
What is difference between Higher calorific value and lower calorific value?