Answer / mahendra mohan srivastava, acc

As you know that 1:4 is rich mortor behalf of 1;6, because
1:4 has 1 part of cemet and 4 part of sand, and in 1:6 has
1 part of cemet and 6 part of sand, so same cement contant
but more sand shown that the fine partical more. so when
fine parical more it wants more water, and if we add more
water in same cement contant the strength will reduce. so
in between 1:4 and 1:6, 1:4 is more power full, instred of
1:6.
now interior wall and Outer wall, outer wall is facing more
climate effect, like rain wind etc.
so we use rich morter in outer wall.

Answer / sunil1505

actaully mortar.M 7.5 means..1:6, 1:4 is gives mor bonding
than 1:6 ..1:6 is more used in RR masonary and SSM, so we
should use both..but 1:4 gives the gud quality..according to
cost..1:6 is ok usable

Answer / ahmed

1:4 ratio will be for internal walls

what is the difference between pumpable concrete and non pumpable concrete

4 Answers  

---

What is code for designing a sheet pile?

2 Answers  

---

Explain creep?

0 Answers  

---

How to determine spacing of bars in slabs or beams

0 Answers  

---

how much quantity of cement,sand and water required for 1 sq feet flooring work .

0 Answers   JMD Group,

---

Camber of 15 mm is to be provided at free end of the cantilever what dose it mean??

1 Answers   MECO,

---

as per is code, what is the minimum content of opc and ppc cement for rcc structure

0 Answers  

---

What is the use of water table & Kreb stone for drain

0 Answers  

---

What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.

0 Answers  

---

what is the mix design for M:60 with micro silica andmetakaoline?

0 Answers   L&T,

---

std heights of c.p fitting from ffl like health faucet,wall mixer,shower arm,european commod,wall hanging commod etc.

1 Answers   Maples,

---

what is the code for classification of bricks

2 Answers  

---