During the testing of Electrical Equipment the test cables should not touch the

During the testing of Electrical Equipment the test cables
should not touch the equipments. For that testing engineers
use to cotton rope to hang the cable from measuring
Equipment to testing equipment terminal. Please explain the
technical reason for this practice.

Question Posted / muthusamy1985

1 Answers
4323 Views
I also Faced
E-Mail Answers

During the testing of Electrical Equipment the test cables should not touch the equipments. For tha..

Answer / k.prakashchandra

This is done while meggering ,so that the measured value
will not be less, due to the proximity of cable with the body.

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Upload data by LSMW via BAPI in SAP system.

1 Answers

how to build a network which step down 415v to 1v rms

0 Answers

In aircraft,why we use 400 htz equipment.and use common earthing

1 Answers

How can I calculate the fault level of a transformer. 1. If fault is 3phase fault 2. If fault is 1phase fault 3. If fault is 2phase fault Dear all geniouses, can you help me by giving answer. If anybody want to send something then mail me at "msalam_shahin@yahoo.com"

0 Answers

what is RMU ?

26 Answers MacLellan, Shalaka Infra Tech,

what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?

0 Answers

my 10 hp submersible pump is tripping when connected through ELCB.I have checked the megger value of the coil's with body.It was found to be 0.2mega ohm.that is leakage is there.But when connected to mccb it is not tripping.no leakage current in the motor.Is it safe to connect to mccb? what are the problem's will arise if future?also tell me in ELCB no neutral is connected to motor.than how ELCB was working?

1 Answers

what is the difference b/c choke and ballast?

1 Answers

what is differentila pilot supervision in the incomer control panel in the power station?

0 Answers

What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?

0 Answers

why the earth terminal in three pin top is longer than rest of the two terminal and of bigger size?

6 Answers BARC, MAHINDRA,

What is the Ramping rate of Generator. What mena Ramping rate

2 Answers Siemens,

For more Electrical Engineering Interview Questions Click Here