During the testing of Electrical Equipment the test cables
should not touch the equipments. For that testing engineers
use to cotton rope to hang the cable from measuring
Equipment to testing equipment terminal. Please explain the
technical reason for this practice.
Answer Posted / k.prakashchandra
This is done while meggering ,so that the measured value
will not be less, due to the proximity of cable with the body.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is meant by twilight switches 7 where its applicable ?
how can you calculate fault level ?
how we can calcultae the short circuit level for bus bar
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
How to calculate VCB rating for 33KV ,25 MW Power line?
In Generator How suction compression power and exhaust works ?
witch pump used in wtp
what do w do when the output of generator is fluctuating?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
What is the purpose of stand by earth fault protection for transformer ?
What is primary and backup protection?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?