Answer / k.prakashchandra

If only one CVT is opted, it is usually provided in the
middle phase( Y). For synch one phase is sufficient.

Why we are not placing c.B 's btwn generator and transformer.? what happens when generator gets disconnected from transformer when it is running @ full load?

3 Answers   Areva,

---

What is the meaning of electricity? How it is being produced? Can we store the electricity? When we produce electricity what is the capacity of voltage current we are getting? If we need 440 volts how to get it? In case, if we want lower than 440 volts how to change it? Please answer?

1 Answers  

---

Why only mesh earthing is used in G.S.S.?

2 Answers  

---

what is the meaning of rms value

24 Answers   Fitter, IOCL, OCL,

---

1.What is the proper definition of power system stability? 2.some times a blue spark is visible in the secondary side of a distribution transformer at the contact position of bushings and fuse wire,why?

1 Answers  

---

What is the basic diffrence between Electronics & Electrical engineering

13 Answers  

---

What is Automatic Voltage regulator(AVR)?

6 Answers   Cummins,

---

what is the full form of KVAR

6 Answers  

---

on whcih cycle does gas turbine works?

2 Answers  

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%

0 Answers  

---

In a company has been installed an analog amperemeter, this company was suplied by generator X, there is no problem in the ampere meter, rigth now this company's supplied by generator Y then the pointer in amperemeter vibrating. What happened? Why? Thank's

2 Answers  

---

What are the characteristics of negative feedback?

0 Answers  

---