Answer / pichumani

It is Lock Out Tag Out Safety process in electrical
maintenance. It is used when any equipment is put under
shut down for repairs or maintenance.

Answer / bhima odedra

LOTO IS LOCK OUT & TAG OUT PROCESSER.
WHENEVER ANY PERSON TAKE SOME MAINTENANCE IN ANY ELECTRICAL
EQUIPMENT,THAT TIME THIS EQUIPMENT TO REQUIRED FOR TOTALLY
ISOLATION FROM ITS POWER SOURCE FOR SAFETY.AND MORE SAFETY
EQUIPMENT POWER SUPPLY PANEL TO LOCKED & ALSO PUT TAG
(DANGER BOARD) ON PANEL WITH NAME WHO WORK IN SYSTEM.and
lock key handover to workman.
THIS SYSTEM CALLED LOTO.
BHIMA ODEDRA
AMBUJA CEMENT LTD.
9879761503

Answer / krishna m

LOTO is 'Lock Out Tag Out'.

If u work in pannel the main source is switched off and
lock the breaker and also mention the details ( who, when,
date)that is Tag.

Answer / vijith

It is a system to isolate any source of energy from its source for carrying out an operation( Maintenance or Modification Works) in its Energy flow line.

Answer / tushar patel

this is tushar patel from ultratech cement ltd.

loto is basically due pont standard for electrical safety.


thanks & regards;
tushar patel
ultratech cement ltd.
cell:9904809055

Answer / k.prakashchandra

It is also called 'Line clear' or 'Work permit'

why wound rotor is star-connected?

4 Answers  

what is static switch where it can be use?

1 Answers  

what is the current setting for different relay protection for transformer .

0 Answers   Crompton Greaves,

why we are not giving the zone 1 trip command to the master trip relay

0 Answers  

Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?

0 Answers   HCL, Reliance,

We have 2 no. 4MW DG set. and GEB supply. But, we running, only 1 DG set. when we done APFC/Power factor setting : 0.90, then winding temp. Low. but when setting done : 0.83, then Winding temp. increase. WHY Why ? ? ?, plz give me answer.

4 Answers  

Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more

0 Answers  

How does HT work & Voltage required?

0 Answers   Adhunik,

why commutator is attached with only dc macine

8 Answers   ONGC,

Safety measures in air circuit breaker

5 Answers   Megatron Solutions, TCS,

Do you know the faults occurs generally in motors and how to rectify them?

4 Answers  

how the ac voltage are selected like 220v,415v,750v,1000v& 1.KV,6.6KV,11KV,33KV,66KV,132KV,220KV & why these are selected like these orders

2 Answers   Jindal, JSW,