Answer / praveen kumar gupta

Analog signals are dynamic in nature means they are
continuous. Magnitude of the signal may change in fraction
as well as abruptly.
Whereas digital signals are static in nature means they are
not continuous .Magnitude of digital singnals may either be
High (1)or low (0).

Answer / shekhar saxena

Sinusoidal waves are called Sine waves and those waves
having fixed value like 0 or 1 is called digital signal.

Answer / dhaval

Anolog signal:-
0 to 99 it's call anolog signal like
termomitter 20c,30c,
Digital sognal:-
0 and 1 it's call digital signal like only
on or off

what is full wave bridge?

4 Answers  

---

Why are calling lagging power factor is a inductive load?

2 Answers  

---

What is a neutral

4 Answers   Adani Ports, Dr Reddys,

---

why we short ckt the secondry vo5tage/ winding in transfr and motor?

2 Answers  

---

How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings

2 Answers  

---

In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil

0 Answers  

---

Maximum efficiency occurs in electrical machines is at i)Full load,ii)50% of full load,iii)Near full load,iv)None of these

1 Answers   IFFCO,

---

why is the size of earth conductor is half of phase conductor.

1 Answers   Century Pulp and Paper, L&T,

---

What is super thermal power plant? and how it will differ from normal thermal power plant

0 Answers   AK, Suzlon,

---

The unit of current is the:(a) Volt(b) Coulomb(c) Joule(d) Ampere

2 Answers  

---

In Transformer testing at Shop test we normally test for vector group, open ckt.,short ckt. but what are the other test performed for transformer once it reaches at site.For e.g:if the transformer is dry having rating 1000KVA?

2 Answers  

---

what is the knee point voltage ? what is differtial rela? what is impedance and % of impedane? what is the postive phase sequance ? negative phase sequane ? and zero sequance impedance ? what is sortcircuit calculaion? why take calculation? define stabilty test ? why? what sentivity test? define merz protection ? what is the burden ? class 5p10, accracy, metering ct take knee point voltage test thet time what heppan why dont take knee point test to metering ct?

0 Answers  

---