Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between analog and digital signal?
- 3 Answers
- 5798 Views
- I also Faced
- E-Mail Answers
Answer Posted / praveen kumar gupta
Analog signals are dynamic in nature means they are
continuous. Magnitude of the signal may change in fraction
as well as abruptly.
Whereas digital signals are static in nature means they are
not continuous .Magnitude of digital singnals may either be
High (1)or low (0).
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why we r not earthed Control cable of C.T. terminals
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
What is the technical difference between On delay timer and a Star delta timer?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the formula for hv test for cable and circuit breaker..????
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
what is fault level of power system ?
how is control wiring coding is done in a CRP panel ?
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
send me any model test paper of clerical post of state bank of india.......
what is the difference between linear choke and suction choke?
What happens if i apply 500V to 440V rotary Switch ?
