15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A

15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help

Question Posted / chinthaka

0 Answers
1624 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

What is the disadvantage in proportional controller?

0 Answers

what is the difference between NC & CNC machine.what is the difference between equipment & machine tool

2 Answers

How much voltage we need to apply in 33kv cable during hipot test of cable

0 Answers

our scope called one core cable for distribution system so we like to use 4 core cable with one equipment grounding conductor so what kind of technical reasons i can say that the 4core is better then 1 core,

2 Answers Elite Construction,

HOW WORK HEAT PLATE EXCHANGER

0 Answers

can we start mulitple 3 phase induction motors with common starter?

1 Answers

why CT output is always raetd 5.regardsof primery curre.

3 Answers ABB, BARC,

What is the significance of 3.5 core cable ????

8 Answers Intelux Electronics,

What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?

0 Answers JSW,

What is the work of IGBT in ups?

2 Answers

If one 10 Hp 3phase induction motor connected in 380volt 50Hz. and again its connected to 380volt 60Hz. howmuch currrent and power take on both time?????

1 Answers

What is meant by Reactor in power system and what are the uses?

11 Answers EEE,

For more Electrical Engineering Interview Questions Click Here