Answer / amit kumar

by using optical pyrometer

Answer / nk

to rtd(resistance temperature detecter)

How to calibration a control valve?

0 Answers  

---

Why the Proximitor supply should be Negative voltage? Why should not we give Positive voltage to the Transducer?

6 Answers   Moser Baer,

---

I want to measure level under vaccum by using DP Tx and vaccum vary between -500 to -670 mmHg and process fluid is accetic anhydride if consider process fluid density 1 kg/cm2. how to calibrate Tx ? consider level is 0 to 100 Cm.

1 Answers   CCC,

---

how to install the Ph and Conductivity analyser? is there are any procedures which has to be maintained.

2 Answers  

---

ORP sensor working principle?

0 Answers   Tata Steel Limited,

---

what is "smart" in smart transmitter ?

4 Answers  

---

when the force applied on load cell the ohms will be varriying .and how its convert ohms to mv generate and have any formulae?

1 Answers   UETCL Uganda Electricity Transmission Company Limited,

---

Why ues 250 ohms Resistor during hart type instruments calibration with hart protocol in details ?

5 Answers  

---

what is maximum vaccume?

4 Answers  

---

What is Droop? What is Step/Gradient Limiter in Turbine Governor control?

0 Answers  

---

protection relay watchdog contact operation?

0 Answers   L&T,

---

Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?

4 Answers   Ecil,

---