what factor is necessary during design of HT & LT MOTORS.
Answers were Sorted based on User's Feedback
Answer / pritesh
its depends on two factors
1. insulation level
2. conductor size
| Is This Answer Correct ? | 3 Yes | 0 No |
What is mean by earthed & unearthed cable? Voltage grade of 1.9/3.3 kV(E), 3.3/3.3 kV(UE), 3.8/6.6 kV(E)what it indicates??
what is timing for mccb 800A tripping?
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
why we use end termination xlpe cable on ht kit
what is the meaning of cable Glanding can you explain brifly?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
What are the loading factors to be considered for transformer sizing/selection?
What is the meaning of GRID?
What is the power factor you maintain at ur organization?
43 Answers Cummins, Exide, Johnson and Johnson, KTC, Microsoft, Powergear, Secure Meters, Suncity Strips, Wheels India,
What type of changeover switch needed to run a load of five 1.5 tonn ACs.
what is meant by VDC ?where its applicable ?
why ohmas low not sutable to transformer.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)