Interested to Buy Any Domain ? << Click Here >> for more details...
what factor is necessary during design of HT & LT MOTORS.
- 2 Answers
- 6448 Views
- ABB, L&T, I also Faced
- E-Mail Answers
Answer Posted / pritesh
its depends on two factors
1. insulation level
2. conductor size
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
how to remover corona effect and hysteresis losses from contactor
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
Vaccum circuit breaker
Define relative stability.
How to calculate energy stored in a capacitance
how to test and calculat the head and discharge in borewell compressor
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
What is dynamo?How it works and what is the function of dynamo in a DG.
