Answer / chandramauli sinha

Electromagnetic flowmeters:
Used to measure all electrically conductive liquids (> 5
µS/cm) with or without solids, e.g. water, wastewater,
sludge, slurries, pastes, acids, alkalis, juices, fruit
pulp, etc.

Used in water/wastewater, chemicals, pharmaceuticals, pulp
and paper, foodstuffs, etc. Electromagnetic flowmeters are
even robust enough to be used in mining.


Mass flow meters:

Virtually all fluids can be measured: cleaning agents and
solvents, fuels, vegetable oils, animal fats, latex,
silicon oils, alcohol, fruit solutions, toothpaste,
vinegar, ketchup, mayonnaise, gases, liquefied gases, etc.

Mass flow, density and temperature (the primary measured
variables) can be used to derive other variables such as
volume flow, solid contents, concentrations, and complex
density functions. i.e. One for all - multivariable
metering.

how to callibrate a new i/p converter

7 Answers   TATA,

---

what happens if we are having very very high cavity and flashing in a control valve..??? is it stops working...immediately... or eroded...slowly

2 Answers  

---

1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?

0 Answers  

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

what is type of protocol used in instrument field to marshalling cabinet cabel. what is the differenance between bus cabel and instrument cabel?

1 Answers   Samsung,

---

what is full form of SMART

46 Answers   Infosys, ITC Infotech, Lanco, Rosemount, Solvay,

---

How to Calibrate Flow Switch in field

0 Answers  

---

Can we get the outpot in c without using getch fiction? Answer is yes but output will stay on display 4 only few second.... But can we get output without using getch and also output will hold on the display...?

1 Answers  

---

what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question

0 Answers  

---

What is the PLC Level & type.

2 Answers   Bhushan Power Steel,

---

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers   Gasco,

---

model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com

0 Answers   Jindal,

---