Answer / rajeshsan

The selection of 4 pole or 6 pole depends on application and speed.

To explain in detail

speed, N = 120f/p
where,
N
f = frequency
p=poles

From above it was clear speed depands on frequency and no of poles.

Answer / shyamkr

actually this depends on the operation of the motor.in most
of the cases 6 pole motor are more beneficial since we get
close wave form of flux as compared to the sine wave.
but when explanation is needed for the motor operation then
4 pole motor is very easy to understand.

how and where megger works?

9 Answers   Power Grid,

---

all electricals questions

2 Answers  

---

why do we generate only 3ph ac?is it possible to generate 4ph,5ph,....?

6 Answers   Accenture, Bhel, Reliance,

---

Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity

0 Answers   NCC,

---

will the introduction of capacitor bank parallel with the induction load reduce power consumption

4 Answers   Nokia, WAPDA Water and Power Development Authority,

---

What is trip and closing coil in cb? Why need of them

0 Answers  

---

Is it possible to get earth resistance value"zero" Ohm practically??? If yes,which type of earthing???

9 Answers   TATA,

---

If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?

0 Answers  

---

In a three-phase full converter, every SCR conducts for a.60deg. b. 120deg. C.180deg. d.90deg

3 Answers  

---

why inverter rating is in KVA

3 Answers   Alstom, JSW,

---

What is d diff. btw MCB & MCCB???

1 Answers   Emerson,

---

What is the specification of service line (ie from electrical post to cut out) used by electricity boards used in india.i mean which material,its size etc.. please give the answer at lalkishan.p@gmail.com

0 Answers  

---