Interested to Buy Any Domain ? << Click Here >> for more details...
which pole motor is best ?4 pole motor or 6 pole motor,why?
- 2 Answers
- 9856 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajeshsan
The selection of 4 pole or 6 pole depends on application and speed.
To explain in detail
speed, N = 120f/p
where,
N
f = frequency
p=poles
From above it was clear speed depands on frequency and no of poles.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
explain all the classes with example
Why High voltage are generate noise ?
why should the primary of transformer be connected in delta in a heat run test?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
what is different between phase and netural
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
what is the difference betweem star connected motor & delta connected motor?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
what is vA rating and class of a ct.
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
