Briefly explain how to get..? maximum resistance can be obtained by using 2 resistors.
Answers were Sorted based on User's Feedback
Answer / priyanka
suppose r=10ohm then in series 10+10=20ohm
& in parallel r=100/20=5ohm.So,connect it in series.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / sujeet singh
connect both resistance in series and by reduce ambient
temperature. this(reduce temp.) will increase few ohm of
resistance. because when temp increases the conductivity of
resistor increases and vice versa is also vital truth.
| Is This Answer Correct ? | 0 Yes | 2 No |
What is meant by step-up and step-down chopper?
hello sir, could u plz send me a sample placement paper for hpcl trainee engg exam..(electronics stream)...hoping to hear from u at the earliest. Thanking you.
What size of a UPS can support a NetGear ProSafe GS752TP Switch (512.8W), up to 4 hours? What size of battery(s) needed & how many?
0 Answers Omni Globe International,
Explain what is a state table?
What will be maximum output current of a 30KVA isolation Transformer?
is multiplexing used in 8085 or not ?
why should you consider youself fit to be hired by jspl
why we prefer LED as light source insted of Laser in FSO (FREE SPACE OPTIC)communication.plz give me answer soon
Explain the operation of multistage control of ac voltage controllers with neat diagram?
What is op-amp?
How to increase the gain and directivity of an antenna?
What is impulse response?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)