if one of the phase is failed to 3 phase IM. what will happen?

Categories >> Engineering >> Electrical Engineering
Suggest New Category

Question Posted / paddu241

6 Answers
9469 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

if one of the phase is failed to 3 phase IM. what will happen?..

Answer / b2

it will be run but not for mor time and after some time it
will be burn out

Is This Answer Correct ?

16 Yes

0 No

if one of the phase is failed to 3 phase IM. what will happen?..

Answer / abhishek sinha

motor runs for some time with less speed because one of the
phase is gone and current increases in two phases,after
some time if no protection act than motor will burn.

Is This Answer Correct ?

12 Yes

0 No

if one of the phase is failed to 3 phase IM. what will happen?..

Answer / shishir dubey

if one of the phase of induction motor is failled then it
will rotate but it draws higher current from the supply
mail and if insulation is poor or not able to withstand
the supply current then after some time it will burn.

Is This Answer Correct ?

5 Yes

0 No

if one of the phase is failed to 3 phase IM. what will happen?..

Answer / veerendra

single phasing occur on motor so motor run 50%load for some time and draw more current causes more current overheating of motor and motor will burn after a certain time

Is This Answer Correct ?

4 Yes

0 No

if one of the phase is failed to 3 phase IM. what will happen?..

Answer / jack

It will run for few second after that relay will trip becous High current will flow in two other phases so that's why our motor will not burn.😊😉

Is This Answer Correct ?

0 Yes

0 No

if one of the phase is failed to 3 phase IM. what will happen?..

Answer / paddu241

It will continue to rotate with synchronous speed.

Is This Answer Correct ?

4 Yes

13 No

Post New Answer

More Electrical Engineering Interview Questions

What are the protections to be used for Generator?

5 Answers

If a motor of 30KW rating &200 mtrs distance from feeder give me the cable size selection calculation?

0 Answers

What are the differents between Breaker & Contactor?

8 Answers

how is reactive power controlled on the transmission system

2 Answers

please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in

0 Answers

if there is a voltage difference between neutral and earth when we operate any instrument for fraction of time then where is problem?

1 Answers

what is power factor?

9 Answers MAHINDRA,

how the percentage impedance affect the transformer loading when connected in parallel.?

1 Answers

how percentage impedence effect on the size of the power transformer?

2 Answers Bhel,

Why synchorised generators are used for the production of electricity?

0 Answers

what is RTU with SCADA connection ?

2 Answers

Using 11000V/433V,3 ph,50Hz,500 KVA, what is the maximum capacity of motor in KW that can be connected and started at a single moment? Also explain about any calculations and formulas used in deriving the same.

4 Answers

For more Electrical Engineering Interview Questions Click Here