I have 380.KVA DG set how to Calculate the units from DG.

Answers were Sorted based on User's Feedback



I have 380.KVA DG set how to Calculate the units from DG...

Answer / basavaraj

that depends upon the load p.f,with out considering the
load p.f 0.8, if we run DG for 1 hour it will generate
304kwh

Is This Answer Correct ?    17 Yes 2 No

I have 380.KVA DG set how to Calculate the units from DG...

Answer / azam

Physically You need 3 phase energy meter and 3 ct‘s to measure the units on hourly~monthly basis
By formula calculation is simple
power factor=kw/kva
KW=√3VIcosØ

Is This Answer Correct ?    0 Yes 3 No

Post New Answer

More Electrical Engineering Interview Questions

what is the working process of over & under voltage relay.

0 Answers   NTPC,


in the thermal power plant, why we use the condenser (for cooling the steam) when we have to heat the steam again. i mean why we are cooling the steam,

6 Answers  


what is the use of providing earthing for tanks? i know for lightning we use earthing ? Here one of my ONGC project there is no need of lightning protection and there is no power connection near by tank in that situation also ONGC asking earthing for tanks but we didn't understanding why they asking earthing? is anybody tell exact answer?

4 Answers  


Hi, We have have the major losses between BBT ( Bus Bar Trunking) to LT Incomer & LT to HT incomer, how to arrive the losses?

1 Answers  


In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?

0 Answers  






we have taken HV test of 2.5 k and Megger test on 11 kv HT cable.here it shows no fault but when we are charging the same cable with 11 kv supply why the VCB 11 kv gets tripped can anybody define the possible cause of fault ?

4 Answers   MAHINDRA,


what is the difference between the characteristics of two different phase bushing of any transformer

0 Answers   NIT,


what is the principle of operation of synchronous motor and generator? explain in detail.

2 Answers   Maruti Suzuki,


why knee point voltage should be high in Ct for differential protection

1 Answers   NTPC,


what type of euse we should use ? 1- High resistance & low temperature 2- High temperature low resistance

2 Answers  


what is the function of turbo charger in disel generators

1 Answers   Kirloskar,


What is Servo Ventilated Motor?

0 Answers   L&T,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)