Give a brief idea about Control circuit wiring in
Substation...???
Answers were Sorted based on User's Feedback
Answer / waseem aslam
Control circuit wiring of substation refers to wiring of protection relays of transformer with the circuit breaker and wiring of over-current/earth-fault protection relay in the CB, including manual tripping operation.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / k.prakashchandra
The control circuit is for opening and closing on command.
Is This Answer Correct ? | 0 Yes | 1 No |
why transformer rating is always in KVA
what is the principle of vvvf drive motor
What should be the value of earth resistance for an instrumentation/electronic circuit? As per which IS/IEC Code?
which VFD is better ( LT or HT)
Why capacitor is blow when I am starting motor ?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
IF we have 500kva transformer & know the current on HT & LT side, how can we consider for its breaker?
What we mean by vintage of an engine+Generator?
WHY AIR COMPRESOR IS STARTED UNLOADED
Shall we get electrical shock if we touch the positive terminal of a 230 volt dc supply?
please tell me formula of 3 phase induction motor under condition{1]when we 3 phase motor starts without load in star or delta connection?thanks