Answer / Abid Hussain

A circuit recombiner is a device used in three-phase power systems to combine two or more lines of the system. It allows currents in different phases to be redistributed among each other to minimize harmonic distortion. A circuit breaker, on the other hand, is a protective device that can detect faults and interrupt the electrical current flow in case of an overcurrent or short-circuit condition. Unlike a recombiner, a circuit breaker does not typically redistribute current but isolates the faulty section.

Difference between field rheostat and armature rheostat.

1 Answers  

---

Why is it that North America uses 60 hz frequency while Europe uses 50 hz?

4 Answers  

---

how to apply b license to c license in tneb

1 Answers   Billroth Hospitals,

---

what will happen to the core losses if we perform the open ckt test on high voltage side of a transformer ?

2 Answers  

---

What is the function of mid point voltage in battery bank

1 Answers   Jindal Steel and Power,

---

Explain Continuous and Discrete signals?

1 Answers   UOG,

---

What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?

1 Answers  

---

Explain how Hormonics will effect the Electrical System?

5 Answers  

---

What is the difference between amorphous core transformer and CRGO core transformer?.

1 Answers   DAE,

---

what happen to the voltage and current in all phases when an earth fault occur in a phase in three phase three wire system(delta connected)...

1 Answers  

---

Radio Carbon dating is used in a) find diseases b) find the age of relics c) find the carbon content in the atmosphere d) none of these

2 Answers  

---

how can calculate static 3phase 4wire CT & PT operated energy meter constant when calibrating using refference meter suppose we have 11kv/110v PT and 30/5A CT, the meter constant is 160imp/kwh, where meter is showing MW energy? give me solution which constant i feed in my refference meter for calibration of energy meter?

3 Answers  

---