Give a brief idea about Control circuit wiring in
Substation...???
Answer Posted / waseem aslam
Control circuit wiring of substation refers to wiring of protection relays of transformer with the circuit breaker and wiring of over-current/earth-fault protection relay in the CB, including manual tripping operation.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why do we perform an open-circuit test and short-circuit test on the transformer?
what are the applications of TIG welding
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
what is the write prosidure of stringing of 8meter pcc pole.
What is vaccum currcuit breaker.define with cause and where be use it device?
What is the technical difference between On delay timer and a Star delta timer?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
Ceiling Fan and Storage type water heater. Discuss
what about electrical pannel.? What is meant by plc pannel.?
What the main causes of transient interruptions on Over-Head Distribution Lines?
What happens to a motor if it is connected in Delta connection
difference between crane drive and line drive.